motogadget motoscope mini

Housing

The high-quality aluminum housing is milled from a solid aluminum block and its surface is anodized black or high gloss polished. The electronics are completely encapsulated in the housing and thus protected against weather, water, dust and vibration.

Display and functions

The innovative dot matrix of 251 ultra-bright LEDs displays the speed by a scalable horizontal light band and all other functions as numerical values. RPM count can be called up as a numerical value at the touch of a button. To achieve optimum readability in darkness, sunlight and twilight, the luminosity of the LEDs is automatically adjusted. A speed value can be entered for the limit range of the permissible speed ('red range') or as a switching flash function. If this value is exceeded, all LEDs light up pulsatingly at the same time. Special feature: the display of the motoscope mini can show the numerical values not only from left to right, but also from top to bottom. Therefore the instrument can also be mounted upright!

Operation

The supplied menu button or e.g. the light horn button on the handlebars is used to switch between values on the display. The default display is the speed value. If required, the other measured values can be brought onto the display by briefly pressing the button. Optionally, it can be set that the display automatically returns to the speed value after a short time or that a specific value is fixed. Pre-settings or stored values remain saved even without power supply, of course.

Mounting

Due to its very small dimensions, the motoscope mini can be easily mounted almost anywhere on any vehicle. Stand alone on the fork bridge or handlebars, in existing instrument panels or recessed in the tank or in tank or GFK - the instrument can be integrated everywhere. We at RF-Biketech manufacture specific triple clamps or handlebars that are prepared for the motoscope mini. Please give us a call or contact us via mail.

Connection and sensors

The simple wiring make the connection of the instrument possible even for users who have not previously dealt with vehicle electrics. The included stainless steel speedometer sensor is very small (M5/25 mm). With the 1.5 m long connection cable, it can be easily attached to the front or rear wheel. Even vehicles with original mechanical speedometer drive can be easily converted with it. The motoscope mini is compatible with many original speedometer sensors (reed contact and proximity sensors) of the vehicle manufacturers. In this case, only connections are connected and the mechanical installation of a sensor becomes unnecessary. An intelligent 'teach function' allows easy calibration of the speedometer - even on vehicles with sensors on the transmission.

Technical data:

• Length/width/depth: 59 mm/21.5 mm/13 mm
• Weight: approx. 32 g
• Mounting: 2 x M3 threaded bush
• Current consumption in operation: approx. 100 mA
• Current consumption in idle state: 0 mA
• Operating voltage: 7 V - 18 V
• Operating temperature: -20°... +80°C
• Tachometer (LED bar): 6/ 8/ 10/ 14/ 16 krpm
• Tachometer (numerical): 0 - 20 krpm
• Limit setting/shift flash: 0 - 20,000 rpm
• Speedometer: 0 - 999 km/h or mph
• Trip meter: 0 - 999.99 km or mi
• Total kilometers (adjustable): up to 99 999 km or mi
• Travel time display: 0 - 99:59 h/min

Scope of delivery:

• Instrument with approx. 55 cm connection cable
• Complete plug connection
• Fuse
• Speedometer sensor with 150 cm connection cable
• 2 x magnet
• Mini pushbutton
• 3x VA screws M4
• QR code for the mounting and operating instructions

Please note that temperature and pressure sensors must be ordered separately.