Our custom made license plate holder for the Kawasaki Z 900 RS will be delivered completely ready for installation, including reflector and E-certified LED-license plate light, which is covered by the tail light. The license plate holder is available for the original turn signals or all common mini turn signals. The holder can also be installed with the original side reflectors, however they have to be placed a little bit differently (four little spacers are included in the delivery) Turn signals are installed at the very top, the license plate light is completely covered by the tail light so you can't see it directly. Therefore the holder can be installed directly below the tail light. Material: Stainless steel black powdercoated – fits on all Z 900 RS models. Fits best for license plates from 180mm to 240mm width. Scope of delivery: License plate holder with reflector and E-certified LED-light, 4x spacers The license plate holder is not TÜV-eintragungspflichtig. (Germany)

Our short license plate holder for the Kawasaki Z 650 RS from our own production including reflector and E-approved LED license plate light. Supplied completely ready to fit, optionally for original turn signals or all common mini turn signals - please specify the respective variant. It is also possible to get both holders (for mini-turn signals and original turn signals), to do this, select the appropriate variant. After installation, the license plate light is completely hidden, the license plate can be mounted directly under the tail light and sits as high as possible. The license plate holder is made of steel and is black powder coated. Suitable for license plates from 180 mm to 240 mm wide. Note: By removing the original license plate holder, the EURO 5 side reflectors are omitted. It is recommended to attach side reflectors (yellow) to the fork instead. Details and scope of delivery: License plate holder short Z 650 RS incl. reflectors, E-tested LED license plate light Material: Steel Surface: black matt powder coated Mounting material Information TÜV: The license plate holder is not subject to TÜV registration.

We used this chrome fender on many different custombikes in the past and we will continue to do so. Especially for Zephyr 750/1100 and ZRX 1100/1200 we also have two holder kits in our store (visible at the bottom of the page). Attention: Unfortunately, the fenders are not in perfect condition. Upon closer inspection, you may notice that the inner weld points are slightly visible on the chrome surface, or there are very small scratches. Therefore, we are offering the fenders at a special price — instead of €189, now only €139. Once the fender is mounted, these minor "flaws" are hardly noticeable. Scope of delivery: Fender, chrome-plated steel

The original! CNC-milled screw-in spacers are screwed between shock absorber and swing arm - the rear is raised by about 3 to 4 cm. Info about TÜV: TÜV-Einzelabnahme required, material specification as well as TÜV sample of an identically constructed vehicle with corresponding entry are supplied, the TÜV entry in our house is guaranteed. Scope of delivery: 2x rear spacer holding screws material specification, TÜV sample report of identical vehicle

License plate holder suitable for all Kawasaki Z 900 models from 2025 onwards. The license plate bracket is made of 2.5 mm steel, is powder-coated in silky matte black, and has an infinitely adjustable tilt angle. Includes LED license plate light and reflector (both E-approved). Turn signal holders (8.5 mm diameter, for M8 thread) for mini indicators are also infinitely adjustable in width. Installation: Installation is very easy and works plug & play. Note: The "Z" on the holder is intentionally mirrored. Once the license plate is mounted, the Z can be read correctly. Scope of delivery: License plate holder Mounting screws