motogadget chronoclassic

Housing

The high-quality aluminum housing is turned and milled from solid on CNC machines. The surface is brushed and anodized black or natural aluminum. The housing has a vent valve with Gore membrane, which prevents fogging. The sight glass of the instrument is made of a scratch-resistant special plastic. Due to the widely 80 mm, original instruments can often be replaced very easily. be replaced.

Analog display with pointer and LC display

The speed is optimally readable with the red pointer on a white dial. dial for optimum readability. The innovative, full-surface backlighting backlighting, the maximum surface area is used for the dial. When the instrument is switched off, no symbols are visible. Freely freely adjustable transmission factors and pointer damping enable precise and precise and jitter-free speed indication by the stepper motor. The LC display is very easy to read even in direct sunlight and is illuminated. Four ultra-bright control LEDs complete the instrument. The red LED functions as a warning lamp when the entered limit values for speed, temperatures (min./max.), pressure measurement (min./max.), on-board voltage as well as for the oil pressure switch or similar existing sensors. Different warning functions are indicated by different flashing or continuous light.

Installation

Due to the common installation diameter the instrument is easy to install on many vehicles. We at RF-Biketech offer triple clamps that are specifically prepared for the cockpit. Please contact us via phone or e-mail.

Connection and sensors

The connection cable has a length of approx. 55 cm, the connector plugs are ready installed. For the vehicle side the corresponding counterparts are supplied. The input for the RPM measurement is simply connected to the ignition coil or ignition box. The included stainless steel speedometer sensor is small (M5/22 mm) and can be easily attached to the front or rear wheel with the 1.5 m long connection cable can be easily attached to the front or rear wheel.

Operation

With a menu button or e.g. the light horn button at the handlebars is used to switch between the displays of the LCD. The first line shows the speed permanently. Further measured values can be displayed by keystroke on the display. Settings or stored values are retained and stored even without power supply.

Technical data:

• Mounting diameter: 80 mm
• Overall diameter (screw ring): 85 mm
• Housing depth without cable gland: 34 mm
• Weight: approx. 230 g
• Mounting: 3 x M4 threaded bush
• Current consumption in operation: 200 mA
• Current consumption in idle state: 0 mA
• Operating voltage: 9 V - 18 V
• Operating temperature: -20°C to +80°C
• Tachometer (analog/pointer): 0 - 8, 10, 14 krpm
• Speedometer (LCD): 0 - 350 km/h or mph
• Trip meter up to 999 km or mi
• Total kilometers (adjustable) up to 250,000 km or mi
• Travel time display: 0 - 99:99:99 h/min/s
• Tachometer (on LCD): 0 - 20.000 rpm
• adjustable speed warning (int. LED and ext. switching flash): 0 - 20.000 rpm
• On-board voltage display: 9 V - 18 V
• NEW! Undervoltage warning LED flashes when on-board voltage drops below approx. 11V, replaces charge control lamp
• Air temp* (optional instead of water temp.): -20 - 80 °C / -4 - 17°F with High-/Low-warning
• Water temperature* (optional instead of air temp.): 40 - 120 °C / 104 - 24°F with high/low warning
• Oil temperature*: 40 - 160 °C / 104 - 320 °F with High/Low warning
• Oil pressure*: 0.5 - 8 bar / 8 - 116 psi with high/low warning
• Time measurement: 0 - 100 km/h o. 0 - 60 mph 0.0 - 99.9 sec.
• instantaneous acceleration: (-20.0) - 20.0 m/s2
• Average speed: 0 - 350 km/h o. mph
• Maximum speed: 0 - 350 km/h o. mph
• Maximum speed: 0 - 20,000 rpm
• max. positive acceleration: 0 - 20.0 m/s2
• max. negative acceleration: 0 - (- 20.0) m/s2
• Gear indicator: N, gear 1 - 6
• green control LED: idle (N)
• yellow control LED: turn signal left, right
• blue control LED: high beam
• red control LED: for various warning functions external (e.g. oil pressure switch), internal (speed, temperature, pressure, voltage)
• Output for ext. switching flash lamp, switching capacity max. 1.4 A

Scope of delivery:

• Instrument with 55 cm connection cable & connector
• Cable fuse
• Speedometer sensor with 150 cm connection cable & two magnets
• Mini pushbutton
• Stainless steel mounting screws
• QR code for mounting and operating instructions

Please order temperature and pressure sensors under accessories separately.